Ultra Stick Hangar 9 Manuel d'instructions télécharger pdf (Page 21)

21Hangar 9 Ultra Stick 40 ARF Assembly Manual

 Step 4

Use a pin vise and 5/64-inch (2mm) drill bit to drill the holes

for the screws. Use 2–3 drops of thin CA to harden the holes.

Secure the control horn to the rudder using two 2-56 x 5/8-

inch machine screws and a control horn backplate.

 Step 5

Enlarge the holes in a 180-degree control horn that are 9/16-

inch (14mm) and 3/8-inch (9.5mm) from the center of the

servo horn.

Note: If you are building the tail dragger version it

is not necessary to enlarge the hole that is 3/8-inch

(9.5mm) from the center of the servo horn.

Note: If you are building the tail dragger version, you

can skip step 6.

 Step 6

Use side cutters to remove the unused arms from the servo

horn using diagonal cutters. Attach the pushrod connector to

the inside hole of the servo arm as shown. Make sure to use

threadlock on the nut so it doesn’t vibrate loose.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Pas de commentaire

Ultra Stick Hangar 9 Manuel d'instructions Page 21