Ultra Stick Hangar 9 Manuel d'instructions télécharger pdf (Page 18)

18 Hangar 9 Ultra Stick 40 ARF Assembly Manual

 Step 3

Fit the rudder to the fin. Use a hobby knife and #11 blade to

check the hinge gap and that the rudder is not rubbing the top

of the fin.

Note: If you are installing the tail wheel, use 30-minute

epoxy to glue the tail gear bushing into the fuselage.

 Step 4

Use thin CA to glue the two hinges that secure the rudder and

fin. Perform a pull test on the hinges and break them in at this

time.

Elevator Installation

Required Parts

Fuselage assembly CA hinge (6)

Elevator

Tools and Adhesives

Drill bit: 1/16-inch (1.5mm) Pin vise

Thin CA T-pins

Rotary tool with sanding drum (optional)

Felt-tipped pen (optional)

Note: This first step is only necessary if you are

installing the tail wheel. If you are building the tricycle

version, skip to Step 2.

 Step 1

Position the elevator against the stabilizer. Use a felt-tipped

pen to mark where the tail wheel wire rests against the

elevator. Use a rotary tool and sanding drum to make a notch

so the elevator does not bind against the wire.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Pas de commentaire

Ultra Stick Hangar 9 Manuel d'instructions Page 18